Key Fob Programming Instructions For Chevrolet Oldsmobile Pontiac L2C0007T 3 Button

Important Notes Before You Start:

  • This procedure requires one working ignition key
  • This procedure works with the following vehicles: Chevrolet Venture, Oldsmobile Silhouette, and Pontiac Montana

Programming Instructions

    1. Ensure that all remotes expected to work for the vehicle are present. Any remotes that are not present will stop functioning until they are reprogrammed
    2. Remove the key from ignition cylinder
    3. Unplug the BCM PRGRM fuse or MALL PGM fuse from the fuse box (you only need to remove one fuse)
    4. Close all doors
    5. Insert the key in ignition cylinder and turn it to "ACC" position by turning it counterclockwise
    6. Within 1 second, turn the key to "OFF" position then back to "ACC" position
    7. Open the driver's door
    8. Close the driver's door
    9. A chime will sound indicating that the vehicle has entered the programming mode
    10. Press and hold the door "LOCK" and "UNLOCK" buttons on the remote for up to 15 seconds
    11. Two chimes will sound indicating that the remote has been successfully programmed
    12. Repeat step 10 for the remaining remotes including the working remotes
    13. To exit the programming mode, please remove the key from ignition cylinder
    14. Plug the fuse that was removed in step 3
    15. Test all remotes

    Leave a comment

    All comments are moderated before being published