Key Fob Programming Instructions For Jeep and Dodge OHT692713AA

Important Notes Before You Start

  • This procedure requires two working programmed or original key fobs
  • An automotive locksmith or dealership programming is required if:
    • Your vehicle year is 2010 and up
    • An ignition recall was performed on your vehicle
    • Two working remotes are not available

Programming Instructions Are Applicable For The Following Vehicles

  • 2007-2009 Dodge Nitro
  • 2007-2009 Jeep Compass
  • 2007-2009 Jeep Patriot
  • 2007-2009 Jeep Wrangler

Programming Procedure

  1. Insert the first working remote into the ignition
  2. Turn ignition to On position and wait for 3 seconds
  3. Turn the ignition to Off position and remove the remote
  4. Wait 15 seconds then insert the second working remote into the ignition
  5. Turn ignition to On position and wait 10 seconds
  6. The immobilizer warning light on dashboard will turn on and you will hear a tone
  7. Turn ignition to Off position and remove the remote
  8. Within 50 seconds, insert the new remote into the ignition and turn it to On position
  9. Wait 10 seconds and you will hear a tone and the immobilizer warning light on dashboard will stay on for 3 seconds, which means that the remote programming is complete
  10. To program additional remotes, you must repeat the steps starting from step 1 for each remote
Helpful Links

Leave a comment

All comments are moderated before being published